Time Based Output

May 11, 2020

PRODUCTS NEEDED:

👉 ANY POWERFT ECU

👉 DAVIS DRIVESHAFT SENSOR & COLLAR

👉 HALL EFFECT RPM SPEED SENSOR

1. Open FTManager Software, go to Map Options and enable Time Based Output.

2. Next, in the Quick Access Panel under Drag Race Features, find Time Based Output.

3. Choose the time you want the output to turn on.

4. Select if the output will just be turned on or if it will be pulsed.

5. Check this box if you want a minimum RPM to trigger and program that RPM into the software.

6. Check this box if you want a minimum TPS requirement and program what minimum TPS percentage you need.

7. Next, you can select if you want a minimum driveshaft speed and program what RPM you need.

8. You can also choose a minimum vehicle reference speed required.

9 . Finally, program how you want the output to function: 0v or 12v.

Also in Tech Support Articles

How to Set-Up Transmission Dump Valves

October 22, 2024

Learn how to configure transmission dump valves with FuelTech ECUs for optimal engine tuning and performance. This guide covers internal and external dump valves, their benefits for turbo spooling and power management, and step-by-step setup in FTManager. Perfect for professional engine tuners and racers looking to gain a competitive edge on the track.

Read More

How to Set-Up Drive-By-Wire

October 18, 2024

Making drive-by-wire easy with this step-by-step guide that walks you through wiring and configuration in FuelTech's FTManager ECU software.

Read More

How to Wire and Set-Up Fuel Level Sensors

October 16, 2024

Learn how to set up a fuel level sensor on a FuelTech ECU with this step-by-step guide. From wiring the sensor to configuring it in the ECU's software, this article covers everything you need to monitor your vehicle's fuel levels accurately. Optimize your FuelTech system for real-time fuel management and improve performance with this easy-to-follow tutorial. Perfect for DIY enthusiasts and professionals alike.

Read More