Our site is not fully compatible with Internet Explorer. We strongly suggest using Google Chrome, Firefox, Safari, or Edge.

Time Based Test Features

May 04, 2020

1. OPEN THE FTMANAGER SOFTWARE AND OPEN YOUR CURRENT TUNE FILE

PRODUCTS NEEDED:

👉 ANY POWERFT ECU

👉 SWITCH PANEL CONTROLLER

👉 STAGING / BRAKE CONTROL SOLID STATE RELAY

👉 NITROUS SOLID STATE RELAY

2. NEXT, IN THE QUICK ACCESS PANEL UNDER DIAGNOSTIC PANEL, GO TO TEST TIME BASED FEATURES.

3. CLICK ENABLE

4. ONCE ENABLED, SELECT THE ENGINE RPM, TPS, MAP AND TEMPERATURES YOU WANT THE ECU TO STIMULATE

5. MAKE SURE TO TURN ON ANY ARM SWITCHES FOR NITROUS, ETC.

6. PRESS AND HOLD YOUR 2 STEP BUTTON AND THE TEST WILL BEGIN. YOU WILL SEE THE GREEN TIMER START COUNTING UP, THIS FEATURE WILL RUN ALL TIME BASED OUTPUTS AS IF THE CAR WERE GOING DOWN THE TRACK

Also in Tech Support Articles

How to Set-Up Transmission Dump Valves

October 22, 2024

Learn how to configure transmission dump valves with FuelTech ECUs for optimal engine tuning and performance. This guide covers internal and external dump valves, their benefits for turbo spooling and power management, and step-by-step setup in FTManager. Perfect for professional engine tuners and racers looking to gain a competitive edge on the track.

How to Set-Up Drive-By-Wire

October 18, 2024

Making drive-by-wire easy with this step-by-step guide that walks you through wiring and configuration in FuelTech's FTManager ECU software.

How to Wire and Set-Up Fuel Level Sensors

October 16, 2024

Learn how to set up a fuel level sensor on a FuelTech ECU with this step-by-step guide. From wiring the sensor to configuring it in the ECU's software, this article covers everything you need to monitor your vehicle's fuel levels accurately. Optimize your FuelTech system for real-time fuel management and improve performance with this easy-to-follow tutorial. Perfect for DIY enthusiasts and professionals alike.